反推力装置运动学与动力学仿真

为了研究叶栅式反推力装置各部件在工作过程中的运动学与动力学特性,根据机构运动原理对反推力装置进行简化并建立了运动学与动力学数学模型。以滑动整流罩位移与阻流门所受气动负荷为输入进行运动学与动力学仿真,得到了反推力装置各部件的位移、速度及受力特性曲线,并对比分析了在不同尺寸参数下各部件特征点的运动轨迹和反推力装置负载力变化。结果表明:运动学及动力学仿真结果与工程实际相符；反推力装置机构参数选择不合理时,各设计点会发生干涉现象并导致机构无法运动;机构参数变化对负载力最大值影响尤为突出,在阻流门AC段长度值增大6%,阻流门CB段长度值减小9%的情况下,负载力正向最大值将增大19.53%,负向最大值增大12.67%。研究方法及研究结果可为反推力装置运动学及动力学分析,以及为反推力装置机构优化设计提供参考。      

航天器姿态预设性能控制方法综述

针对存在不确定惯量矩阵及其它未知不确定性(如执行器故障、航天器结构发生突变等)下的航天器姿态控制问题，综述了预设性能控制及其应用的研究进展。首先阐释了预设性能控制方法的基本内涵及其关键步骤；然后分析总结了现有航天器姿态控制以及预设性能控制研究的基本概况与发展趋势；最后面向未来复杂化、智能化的空间任务对航天器控制系统提出的新需求，提出航天器预设性能控制值得研究的问题和方向。     

Evaluation of SARAL/AltiKa performance using GNSS/IMU equipped buoy in Sajafi,Imam Hassan and Kangan Ports

Performance of SARAL/AltiKa mission has been evaluated within 2016 altimeter calibration/validation framework in Persian Gulf through three campaigns conducted in the offshore waters of Sajafi, Imam Hassan and Kangan Ports, while the altimeter overflew the passes 470, 111 and 25 on 13 Feb, 7 March and 17 June 2016, respectively. As the preparation, a lightweight buoy was equipped with a GNSS receiver/choke-ring antenna and a MEMS-based IMU to measure independent datasets in the field operations. To obtain accurate sea surface height (SSH) time series, the offset of the onboard antenna from the equilibrium sea level was predetermined through surveying operations as the buoy was deploying in the onshore waters of Kangan Port. Accordingly, the double-difference carrier phase observations have been processed via the Bernese GPS Software v. 5.0 so as to provide the GNSS-derived time series at the comparison points of the calibration campaigns, once the disturbing effects due to the platform tilt and heave have been eliminated. Owing to comparing of the SSH time series and the associating altimetry 1?Hz GDR-T datasets, the calibration/validation of the SARAL/AltiKa has been performed in the both cases of radiometer and ECMWF wet troposphere corrections so as to identify potential land contamination. An agreement of the present findings in comparison with those attained in other international calibrations sites confirms the promising feasibility of Persian Gulf as a new dedicated site for calibration/validation of ongoing and future altimetry missions.     

Assessment of between-floor structural and topological properties on cognitive map development in multilevel built environments

The present study investigated cognitive map development in multilevel built environments. Three experiments were conducted in complex virtual buildings to examine the effects of five between-floor structural factors that may impede the accuracy of humans’ ability to build multilevel cognitive maps. Results from Experiments 1 and 2 (of three experiments) revealed that difficulties in developing multilevel cognitive maps are not solely caused by the z-axis offset, as is suggested in the literature, but are due to the factorial combination of a between-floor overlap and a z-axis offset. Results from Experiment 2 showed that this process becomes substantially more difficult when the reference directions between different floors have an angular offset from each other. Finally, results from Experiment 3 demonstrated that confusing between-floor heading shifts in aligned buildings did not make it reliably harder to build multilevel cognitive maps. The implications of these findings are discussed in terms of theories of mental representations in multilayered three-dimensional spaces, as well as for architectural design.     

Simulating planetary wave propagation to the upper atmosphere during stratospheric warming events at different mountain wave scenarios

Parameterization schemes of atmospheric normal modes (NMs) and orographic gravity waves (OGWs) have been implemented into the mechanistic Middle and Upper Atmosphere Model (MUAM) simulating atmospheric general circulation. Based on the 12-members ensemble of runs with the MUAM, a composite of the stratospheric warming (SW) has been constructed using the UK Met Office data as the lower boundary conditions. The simulation results show that OGW amplitudes increase at altitudes above 30 km in the Northern Hemisphere after the SW event. At altitudes of about 50 km, OGWs have largest amplitudes over North American and European mountain systems before and during the composite SW, and over Himalayas after the SW. Simulations demonstrate substantial (up to 50–70%) variations of amplitudes of stationary planetary waves (PWs) during and after the SW in the mesosphere-lower thermosphere of the Northern Hemisphere. Westward travelling NMs have amplitude maxima not only in the Northern, but also in the Southern Hemisphere, where these modes have waveguides in the middle and upper atmosphere. Simulated variations of PW and NM amplitudes correspond to changes in the mean zonal wind, EP-fluxes and wave refractive index at different phases of the composite SW events. Inclusion of the parameterization of OGW effects leads to decreases in amplitudes (up to 15%) of almost all SPWs before and after the SW event and their increase (up to 40–60%) after the SW in the stratosphere and mesosphere at middle and high northern latitudes. It is suggested that observed changes in NM amplitudes in the Southern Hemisphere during SW could be caused by divergence of increased southward EP-flux. This EP-flux increases due to OGW drag before SW and extends into the Southern Hemisphere.     

SSPS-OMEGA超大型球形聚光器结构拓扑构型与设计

为同时兼顾千米量级尺度空间太阳能电站聚光系统的在轨发射安装难度、光学收集效率、稳定性及结构工艺等多方面的因素，提出采用基于球面正多面体的经纬线划分法模块化构建球形聚光器。该方法不仅可实现基础划分单元分布均匀、规格种类少，降低在轨构建与运载发射难度。而且只要合理控制弧高等分数和基础划分单元的口径就可以同时保证聚光系统的光学收集效率。理论与仿真结果显示，当弧高等分数为24时，该划分法共有25种基础单元件，整个球面被分成5762块。并且此时模块化构建的实际球形聚光器的光学收集效率与理想球面相比基本保持不变，解决了太阳能电站聚光系统设计中存在的关键问题。     

基于深度学习的毫米波和亚毫米波成像仪的图像增强技术

风云四号卫星毫米波和亚毫米波成像仪(MMSI)数据根据采样方式分为过采样和非过采样数据。由于采样方式的影响,非过采样数据在采样过程中会有一定的信息损失。为解决采用简单的线性插值方法做精细化处理时提升精度有限问题,采用基于深度学习的方法增强MMSI亮温图像,设计卷积神经网络重建风云四号卫星MMSI的亮温图像和风云三号卫星微波成像仪亮温图像。实验结果显示:相比传统的双三次插值方法,在风云三号卫星微波成像仪亮温图像样本上峰值信噪比提升了1.13dB,结构相似度提升了0.01。实验结果表明:对于非过采样亮温数据,采用基于深度学习的方法增强图像具有更高的精度,同时可在其他微波探测仪数据中使用,具有很强的普适性。     

Non-stationarity and cross-correlation effects in the MHD solar activity

The analysis of turbulent processes in sunspots and pores which are self-organizing long-lived magnetic structures is a complicated and not yet solved problem. The present work focuses on studying such magneto-hydrodynamic (MHD) formations on the basis of flicker-noise spectroscopy using a new method of multi-parametric analysis. The non-stationarity and cross-correlation effects taking place in solar activity dynamics are considered. The calculated maximum values of non-stationarity factor may become precursors of significant restructuring in solar magnetic activity. The introduced cross-correlation functions enable us to judge synchronization effects between the signals of various solar activity indicators registered simultaneously.     

基于射线追踪的快速雷达图像仿真方法

为了解决目标识别、隐身目标设计等研究领域对雷达图像需求日益增加的问题,提出了一种基于射线追踪的快速雷达图像仿真方法。该方法利用射线追踪计算每一个射线管的散射电场及其在雷达成像平面的投影坐标,通过将所有射线管的贡献在像域进行累加得到1幅二维雷达图像。通过对不同路径射线的聚类,可实现对散射贡献的分离,从而建立目标部件与强散射源的对应关系,并对复杂目标雷达图像进行解释。给出了Slicy目标的快速雷达图像仿真与算例分析,分析结果表明:基于射线追踪的快速雷达图像仿真方法可对复杂雷达图像进行有效预测,并能对强散射源进行成因分析。     

A modern robust approach to remotely estimate chlorophyll in coastal and inland zones

The chlorophyll concentration of a water body is an important proxy for representing the phytoplankton biomass. Its estimation from multi or hyper-spectral remote sensing data in natural waters is generally achieved by using (i) the waveband ratioing in two or more bands in the blue-green or (ii) by using a combination of the radiance peak position and magnitude in the red-near-infrared (NIR) spectrum. The blue-green ratio algorithms have been extensively used with satellite ocean color data to investigate chlorophyll distributions in open ocean and clear waters and the application of red-NIR algorithms is often restricted to turbid productive water bodies. These issues present the greatest obstacles to our ability to formulate a modern robust method suitable for quantitative assessments of the chlorophyll concentration in a diverse range of water types. The present study is focused to investigate the normalized water-leaving radiance spectra in the visible and NIR region and propose a robust algorithm (Generalized ABI, GABI algorithm) for chlorophyll concentration retrieval based on Algal Bloom index (ABI) which separates phytoplankton signals from other constituents in the water column. The GABI algorithm is validated using independent in-situ data from various regional to global waters and its performance is further evaluated by comparison with the blue-green waveband ratios and red-NIR algorithms. The results revealed that GABI yields significantly more accurate chlorophyll concentrations (with uncertainties less than 13.5%) and remains more stable in different waters types when compared with the blue-green waveband ratios and red-NIR algorithms. The performance of GABI is further demonstrated using HICO images from nearshore turbid productive waters and MERIS and MODIS-Aqua images from coastal and offshore waters of the Arabian Sea, Bay of Bengal and East China Sea.